Close

Chatillon

TG38 Degree Peel

90° Peel Strength Fixture
This fixture features a self-adjusting sliding bed for 90° peel tests. The test plate moves freely in a horizontal position when the pressure sensitive material is removed in order to maintain a 90° peel angle.

Note: The test plate must be supplied by the customer. The FINAT standard states that plate glass should be used. If stainless steel or aluminum is used as a substitute, it should be stated with the recorded results.

Capacity
200 N, 45 lbf

Packaging
Includes upper fixture and lower sliding bed. Does not include test plate. Upper fixture is available separately.

Applications
Used for peel tests on a wide range of materials including sealing tape, labels, laminated coatings, etc.

Measuring peel adhesion at 90° normally gives a lower recorded value than at 180° and allows values to be measured for materials normally giving paper tear. Peel adhesion is defined as the force required to remove pressure sensitive coated material, which has been applied to a standard test plate, under specified conditions, from the plate at a specified angle and speed. This fixture is ideal for use in tests complying with BS5350: Part C10 and FINAT test method No. 2 (FTM 2) – Peel Adhesion, 90° at 300 mm/min (11.81 in/min)

Model PartNo. Description
TG38 01/1907 90º Peel Strength Jig - 200 N (45 lbf)
  01/3203 Upper Fixture Only